Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1993 240 front whee bearing rubber seal 200

posted by  740gt on  Sat Sep 13 12:29 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 29 12:51 CST 2014
[RELATED]

There is a stamp steel washer cap with a lip. In addition there is a rubber gasket. Both of these fit onto the back of spindle prior to the hub installation. Two questions.
1. Does the steel cap lip face towards the bearing or the back plate?
2. The rubber gasket has two edges one is flat then there is a gap then the other edge is larger and conical if viewed from a cut view. Which direction does this rubber gasket face?

Currently I have the steel cup lip facing the back plate.

I first placed the rubber gasket with conical side facing the back plate. I stretched it over the spindle taper the flat edge of the spindle then put the steel cup on then the hub.

A diagram would be helpful.

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1993 240 front whee bearing rubber seal [200]
posted by  740gt  on Sat Sep 13 12:29 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.