Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Manifold studs: 1) removal tool; 2) intake=exhaust? 200

posted by  jon_h on  Wed Oct 29 13:39 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:57 CST 2014
[RELATED]

1) I removed 7 exhaust studs, two missing ~1/4", using 'Craftsman Stud Remover 4458'. 2 required heat. A smaller one would be better as this one binds against the head on the upper studs. (I often just use a vice grips as it will usually slip before breaking off the stud.)

2) Does anyone know if the exhaust and intake studs are the same - same hardness? FCP euro lists exhaust studs (2 brands) but no intake. (Yes, I know they're cheap but when I want to finish a job ...)

Torques are different - 16 ft-lb intake, 23 exhaust - something like that

http://www.epinions.com/reviews/Craftsman_Stud_Remover_4458?sb=1
--
240 drivers / parts cars - JH, Ohio






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Manifold studs: 1) removal tool; 2) intake=exhaust? [200]
posted by  jon_h  on Wed Oct 29 13:39 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.