Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

timing marks 200 1990

posted by  popdaddy on  Tue Jan 13 17:19 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 26 19:26 CST 2014
[RELATED]

hi guys. hope everyone is staying warm, I posted a thread last week about wheel shaking during braking and tryed some of your advice rotating tires, checked lugs ect. on test drtve bigger problem occured intermediated front oilseal blew, oil everywhere. changed all three seals and timing belt and started car, ran rough. broke it back down and reset marks but this time took off distributor cap and notice rotor position. noticed when set according to mark on back cover 3:00 position rotor points to thermostat not #1 plug. this only happen when I turn it to the 4:30-5:00 position in relating to cover mark position. my question is which should I use, cover or #1 plug position. last belt change used the cover marks and ran fine. as I stand now top Cam is on cover mark, crank at TDC using wooded dowel check. has anyone have some insight thanks/will get back with brakes once running






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New timing marks [200][1990]
posted by  popdaddy  on Tue Jan 13 17:19 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.