Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Stripped Rear Driveshaft Bolts 900

posted by  Scuba Steve on  Wed Apr 29 17:48 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Dec 15 16:48 CST 2013
[RELATED]

edit: Hammering the bolts and careful use of a 6mm allen wrench was finally able to free them. For anyone who finds this while searching, the six bolts are 6mm in size and had Loctite red applied to them at the factory. Cleaning out the crud in the bolt hole, plus hammering in the allen wrench + a little heat will help you free them.

Original problem...
I've run into at least a couple of stripped rear driveshaft bolts. These are the Allen head ones at the rear. Any advice for getting these things loose? Otherwise, would removing the center U-joint enable me to disconnect the front section of the driveshaft? This is all part of the transmission swap I've been working on.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Stripped Rear Driveshaft Bolts [900]
posted by  Scuba Steve  on Wed Apr 29 17:48 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.