Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2008 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

122s m40 to m41 swap driveshaft shorten 11.375 inch? 120-130 1968

posted by  uniberp on  Sun Oct 25 17:31 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 31 07:08 CST 2011
[RELATED]

I pulled the driveshaft and m40 transmission, put the m40 next to the m41 and measured the difference in length, which was 11.375". Does that sound about right?

Anything else I should be thinking about? The flanges match ok.

I'll drill and tap the boss on the old cover to accept the o-drive lockout switch.
If you know the tap size that would be helpful.

Or if any has a front section of driveshaft, that would work too, but I still think I'm going to have it balanced at the shop.

Thanks in advance.

Mpergielwalkermi1968220.

--
MPergiel, Walker, MI






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 122s m40 to m41 swap driveshaft shorten 11.375 inch? [120-130][1968]
posted by  uniberp  on Sun Oct 25 17:31 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.