Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1989 780- where does this wire go? 700 1989

posted by  Uncle Dirtnap on  Tue Apr 26 06:46 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

My bertone started cutting out yesterday- I pull over, pop the hood, and notice a spark. There is a green wire with red stripe hanging loose-

It has a barrel connector (like for the temp sensor). It enters the engine bay through the firewall/wheel well on the drivers side along with a handful of other bundles of wire, although it is by itself in its sheath. It will reach to the valve cover, but not any further. It looks like it has been connected, but pulled out.

Wiring diagrams show a green/red connecting to the grey/red for the ICV, but I had traced that harness back and can not find anything. At the same time, there is a much larger gauge green/red connected to the gang resistor near the headlights, so I don't know how correct my green/red guess is.

Any ideas where this thing goes? Thanks!

-rj






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1989 780- where does this wire go? [700][1989]
posted by  Uncle Dirtnap  on Tue Apr 26 06:46 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.