Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Crane ignition/ballast resistor 120-130

posted by  Nathan Courtright on  Sat Jul 16 19:05 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jul 7 23:45 CST 2013
[RELATED]

Ok, so my crane xr700 ignition module is overheatīng and I need to install a ballast resistor (mallory 29440 coil doesn't have one internally). The coil isn't getting hot, but the XR700 is on fire. All the wiring diagrams I've found show to put the resistor in between the "run" wire of the switch and the coil, but My 122 only has One wire coming out (armored coil has been cut). I can splice it into this wire, but will I be creating trouble starting? It seems to me that reducing voltage at start up would be counter-productive....

Anybody using a crane fireball with ballast resistor like this?

Thanks!

Nate Courtright





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crane ignition/ballast resistor [120-130]
posted by  Nathan Courtright  on Sat Jul 16 19:05 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.