Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2023 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

92 93 240 A/C Low pressure switch and connector - diagnosing reparing replacing 200 1993

posted by  JPistos on  Sun Apr 9 11:18 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 10:41 CST 2014
[RELATED]

So I've got two bricks with almost the same problem - both have either faulty low pressure switches or the connector plug/wiring is the problem. Sometimes the A/C works and sometime it doesn't. Fiddling with the connector (removing/replacing) or bending the wires at the connector will sometimes get the A/C going. Sometimes. Usually works best when first starting up, not when it's warm/hot. And when it's working, the switch/connector/wiring problem usually will cause the A/C system to shut off/on several times a minute, causing the engine to hesitate momentarily as the A/C clutch cycles on/off.
Questions: I assume replacing the switch requires evacuating the system and recharge? Any tips on repairing/replacing the connector and wires? I've tried some electric clean spray and dielectric grease, but that wasn't enough.
Thx in advance BB's!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 92 93 240 A/C Low pressure switch and connector - diagnosing reparing replacing [200][1993]
posted by  JPistos subscriber  on Sun Apr 9 11:18 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.