Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

valve shim diameter 200 1982

posted by  muskox37 on  Mon Aug 7 09:50 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 11:54 CST 2014
[RELATED]

I bought some valve shims online for my B23E engine. I installed one of them yesterday and then realized that its diameter was less than the one previously installed. The shim will move around in its holding space to a limited degree. The shim it replaced filled the space and was difficult to remove because of that.

I am envisioning it moving every time it is contacted by the cam and ultimately getting thrown out with resultant serious damage to the engine. Am I worrying unnecessarily or should I get it out of there.

Bob






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New valve shim diameter [200][1982]
posted by  muskox37  on Mon Aug 7 09:50 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.