Hi neighborhood,

Finally got my salvage b21ft off the bed of my pickup and onto the "Delco" foreign engine stand.I sware I dont think it will hold.Got hardened bolts,7/16 on one side and 1/2 on the other side.I never would have imagined that a 4 cyl motor would weigh so much.Took four golfers two hours to figure out how(without a hoist)and it got a bit hairy.But alls well so far.Any reason to believe that a 1000lb stand wont hold the motor?Seems like its about to bust.

Don,back to the low humming at speed from the driveline from my 244.You think its from the center shaft bearing...could it be anything else?Wheel bearings gone dry?Maybe U-joints?Should I replace the entire Propeller shaft from salvage yard,could get it cheap from 89 240.How to tell what the hum/vibration is.Robber bushing at center supper seems supple and intact

Thanks again

Happy New Year to All

RR in snowy Tx