The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Turbo Motor finally on stand/again on noise 200 84

Hi neighborhood,

Finally got my salvage b21ft off the bed of my pickup and onto the "Delco" foreign engine stand.I sware I dont think it will hold.Got hardened bolts,7/16 on one side and 1/2 on the other side.I never would have imagined that a 4 cyl motor would weigh so much.Took four golfers two hours to figure out how(without a hoist)and it got a bit hairy.But alls well so far.Any reason to believe that a 1000lb stand wont hold the motor?Seems like its about to bust.

Don,back to the low humming at speed from the driveline from my 244.You think its from the center shaft bearing...could it be anything else?Wheel bearings gone dry?Maybe U-joints?Should I replace the entire Propeller shaft from salvage yard,could get it cheap from 89 240.How to tell what the hum/vibration is.Robber bushing at center supper seems supple and intact

Thanks again

Happy New Year to All

RR in snowy Tx






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.