Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Question on motor mounts 200 1985

posted by  someone claiming to be Rob Hanley on  Tue Jan 16 16:29 CST 2001 [RELATED]

I've done this job a few times on my '85 using the plywood and jack approach, but was wondering how does a shop change out the mounts? How is the engine supported?

Also, the mounts that I've been using over the last 4-5 years haven't lasted very long at all. I just replaced both sides about 40K miles ago (parts from IPD) and now the left side (from the front of the car, ergo the side of the engine with the earl filter) is sagging again. B*TCH!! Seems like the original factory mounts on this car did their duty for about 90K miles or so.

I don't really want to crawl under there and do this again...how much would an indy. shop charge? The dealer?

Thanks....





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question on motor mounts [200][1985]
posted by  someone claiming to be Rob Hanley  on Tue Jan 16 16:29 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.