Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

rear spacers = cutting fenders? 200 1991

posted by  someone claiming to be Andrew on  Wed Jan 31 21:04 CST 2001 [RELATED]

Hello everybody

Just bought a set of rear wheel spacers for my 1991 240 (20 mm per wheel), and here's what the installation instruction says:

"Cars with tyre P6x195 and 5-spoke rim only: remove approximately 10 mm of the edge as per sketch" (sketch shows rear ferner).

Does it suggest that all tyres wider than stock 185/70-14 will require some sutting work on rear fenders if spacers are installed? If so, what do I do with my 205/55-16 and car lowered 1 inch?

Did anybody cut rear fenders in this manner before or can same be achieved by rolling fender lip upwards?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear spacers = cutting fenders? [200][1991]
posted by  someone claiming to be Andrew  on Wed Jan 31 21:04 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.