Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thanks for help! More Q's, head gasket 200 84

posted by  someone claiming to be Greg Wong on  Tue Mar 27 16:16 CST 2001 [RELATED]

First of all, I would just like to thank the board for the quick words of wisdom on my problem. I have decided to replace the head gasket myself. At this moment, the head is off. Also, the head is 500 miles away, and when I go home next weekend, I hope I can finish the job.

All the exhaust manifold nuts came off easily (thank god for B'laster), and the worst part was the head bolts, which were stubborn, but all came out ok.

I have a question now about the block. It looks like there are some kind of sleeves in the head bolt holes (in the block). What are these? The one furthest back, and on the exhaust side, is poking out of the bolt hole, and won't tap back in. It looks like it moves around a little, but doesn't go into the block. (It sticks up about 2 mm) The rest of them sit flush, or recessed in the block. Is this cause for concern?

I guess that's it for now. I hope I can get some decent weather this weekend.

Thanks for the help!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Thanks for help! More Q's, head gasket [200][84]
posted by  someone claiming to be Greg Wong  on Tue Mar 27 16:16 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.