Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

bumper trim install? 200 89

posted by  someone claiming to be Haroon on  Mon Apr 2 02:50 CST 2001 [RELATED]

How can I get the plastic (2in) trim above the bumper on? Is there a special method to getting it on?

I removed the front bumper, it went on fine. It clipped into place prefect. Then while putting the bumber on, it comes off. It was a bitch putting the bumper back on, it think it's bent (also has crack half way). Would not line up with the bolts. Once I finally put the bumper on, I gave up.

Part of the trim is suppose to slant over the bumper and I can't get the trim to slant while putting it on the clips.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New bumper trim install? [200][89]
posted by  someone claiming to be Haroon  on Mon Apr 2 02:50 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.