Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Removing in-tank fuel pump 200 84

What's up with this fuel return line?

Bentley's says to remove the fuel lines from the top of the sender unit.

(I hate it when the book doesn't tell you HOW to remove things!)

OK, well the supply line is rubber and I proied that off.

But this return line is solid. Can't be removed from the top of the sender unit.

What do I do? Just loosen it under the car and wiggle things out after rotating the lock ring?

And what is thst third tube for? Mine has a rubber cap over it.

But several posts say there is a fuel vent line to remove?

Where is that? The only other fuel line runs from the car-overturn check valve to who knows where.....

but it is not connnected to the top of the sender.

How to I get this intank mump and sending unit out?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing in-tank fuel pump [200][84]
posted by  someone claiming to be Zee  on Mon May 21 03:42 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.