Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Installation of Center Gauge Cluste 200 82

posted by  someone claiming to be David Smith on  Sat Jun 16 05:35 CST 2001 [RELATED]

Hi Guys,

I have the opportunity to purchase (and install) a center gauge cluster unit complete from a 85 240 (GL model), as a change out for my stock DL cluster unit that contains the large clock, speedometer, gas and water temp gauges, etc. The positive points that make this interesting are that 1) the "new" unit from the 85 GL has the large stock tachometer already in place; and 2) the speedometer is in good working order and has many fewer miles on it ("new" speedo = 150 k+ on the odometer, while my speedo = 265k + miles). Which is to say that my old cluster has no tachometer, and the speedometer (and cable) will probably have to be replaced sometime soon.

The question is: How straightforward is it to substitute the new cluster (from the 85 240 GL) for my old cluster (82 242 -- with the Chrysler ignition system)? Are there any problems or incompatibilities that I should know about before proceeding with this project? Thanks for your comments. Hope all is well.

Regards, David Smith





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installation of Center Gauge Cluste [200][82]
posted by  someone claiming to be David Smith  on Sat Jun 16 05:35 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.