Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

installing brake master cylinder 200 1990

posted by  someone claiming to be phil gfell on  Wed Nov 14 04:33 CST 2001 [RELATED]

I'm replacing the original master brake cylinder on a 1990 245 dl, without ABS. Are there any secret tips I need to know. Or...Do I just

bolt it on and bleed it?

How have ya'll cleaned the resevior of old junk? One side is reachable,the

other not so easily wiped out.

Is Bench bleeding needed/helpful?

The last master brake cylinder I put on was a 1950 Studebaker. and I

dont remember those times well.

thanks

phil Gfell





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New installing brake master cylinder [200][1990]
posted by  someone claiming to be phil gfell  on Wed Nov 14 04:33 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.