While I was replacing the flame arrestor under the intake manifold I notice that there was a cable loose. This cable comes from the firewall at the left side of the big round compartment were the brake master cylinder is attached. Three or four wires come out from the above place.

One is the accelarator cable. An other goes along the fire wall to the gray junction box in the fireeall. An other one goes all the way to the front of the car near the air filter compartment.

And the loose one is about 8 inches long (with insultaion), it has a connector at the end of it with a small boot to cover it. The small rubber boot has like rubber ears so you can pull the connector out from where it goes. I looked in the Hanes repair manual and I can not fid were it goes.

Please advice