Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

I Can't get the $@$#%^%$^$ driveshaft off! 700 91

posted by  someone claiming to be Roguls on  Mon Jul 30 13:40 CST 2001 [RELATED]

I am trying to replace my rear main seal and my clutch. I have gotten nowhere.

I have the six bolts off the driveshaft directly underneath the shifter. I can't pry the shaft past the guidepin inside of the tube. How do I do this? Do I have to disassemble the carrier bearing? Its not for a lack of strength; I've got the car jacked high and I had plenty of leverage on the shaft.

Do I have to take apart the rear axle????

One more question while I'm at it.

How should I get the pin out of the shifter assembly, the one that connects to the shifter, right below the boot?

Oh, and should I put a jack underneath the oil pan to sturdy the engine once I take off the tranny crossmember?

WHEW.

Thanks all.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I Can't get the $@$#%^%$^$ driveshaft off! [700][91]
posted by  someone claiming to be Roguls  on Mon Jul 30 13:40 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.