Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Should flame trap holder side port be clear?? 200 1990

posted by  someone claiming to be ScottSC on  Tue Jul 31 13:35 CST 2001 [RELATED]

I just replaced the flame trap on a B230F engine in a 1990 245. When I disconnected the hoses the small side hose dripped a little oil. I tried to clean the trap holder with carb cleaner and tried to run a small wire through the side port to the main body of the holder. It appeared clogged, the wire did not go completely through to the inside of the main body of the holder.

Should this simply be replaced also??

Should there be a complete orifice through to the main body?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Should flame trap holder side port be clear?? [200][1990]
posted by  someone claiming to be ScottSC  on Tue Jul 31 13:35 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.