Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

transmission output shaft bushing/seal 200 1990

posted by  someone claiming to be zakir on  Thu Aug 2 13:34 CST 2001 [RELATED]

If I push up on the driveshaft where it connects to the transmission, it moves with a thud. I also get a clonk like sound sometimes, when the car starts moving. I have also seen transmission oil around that area.

So I am guessing the seal and maybe the output shaft bushing needs replacement. After reading the FAQ on this sites and the haynes manual, I want to clarify if I need some special tool, to hold the output flange from rotating , or does putting the car into park sufficient to stop the flange rotating while I use a socket to loosen the center bolt?

also do I need a puller to pull the flange out. If so what size pullers do I need or are all pullers standard in size?

Thanks - I am just trying to figure everything out before I start the job.

240 automatic Volvo 1990





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New transmission output shaft bushing/seal [200][1990]
posted by  someone claiming to be zakir  on Thu Aug 2 13:34 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.