Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2001 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Driveshaft Support Bearing Size? 120-130 64

posted by  someone claiming to be Jack on  Wed Aug 16 10:33 CST 2000 [RELATED]

I need to replace my Driveshaft Support Bearing on my 1964 122S 2-door. My driveshaft measures approximately 1.80" (using electronic calipers). I understand that these shafts came in 1 3/4 " and 2" sizes. Therefore, I conclude that mine must be 1 3/4" + dirt & corrosion. Now, I ordered a bearing for my 1 3/4" shaft and I was sent a bearing with a 1 3/8" I.D. Will this fit?????

I have heard two "theories":

1. It will not fit. It is too small.

2. It will fit. The shaft steps down to 1 3/8" under the bearing.

DOES ANYONE KNOW WHICH IS CORRECT? IF # 1 IS CORRECT, DOES ANYONE KNOW WHERE TO GET A 1 3/4" I.D. BEARING?

I would like to have the right part on hand when I disassemble this thing!

Thanks very much!

Jack





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft Support Bearing Size? [120-130][64]
posted by  someone claiming to be Jack  on Wed Aug 16 10:33 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.