Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Should I change the main & rod bearings?

posted by  someone claiming to be Bill on  Wed Aug 15 07:39 CST 2001 [RELATED]

The engine ran a very few minutes...maybe 30 minutes before the cam disintegrated ( I had cked all the bores with the same lifter so I missed the fact that I had two oversize lifters! Ooops) So thhis sidaster threw all kinds of metal into the oil that got pumped everywhere...

Question is? is it sufficient to wipe off the bearing shells and burnish a few slightly roughened areas with scotchbrite? Or is there metal embeded at a micron level that is going to get me in a few thosand miles?

In other words shuld I be ordering new bearings?

Thanks!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Should I change the main &amp; rod bearings?
posted by  someone claiming to be Bill  on Wed Aug 15 07:39 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.