Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Fuel Flow Issue 200 1980

posted by  someone claiming to be Ash on  Sat Sep 15 12:27 CST 2001 [RELATED]

I am having a problem with fuel flow. After my engine is warmed up in will stay running for about 10 minutes (more if idleing) and then the fuel flow to the injectors stops. I disconnected by fuel feed after the filter on the firewall and it is still spitting gas. I disassembled my control pressure regulator and the system acted the same. I think I'm having the pressure cut off somewhere between the fuel distributer intake and the out put for the jets. There is only one part I can't seem to isolate from the feed system, A samll round control unit with an in and an out line from the fuel distributer, it has a electrical set of wires and is located on a mount bracket attached to the air intake. The piece is located on this bracket just in front of the rubber feed bubble.

Could this be causing my problem? What does it do? what is it called? Any other ideas on things to try?

-Ash





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Flow Issue [200][1980]
posted by  someone claiming to be Ash  on Sat Sep 15 12:27 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.