Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2009 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B20 rebuild - oilpump/dist gear orientation 120-130 1967

posted by  someone claiming to be Danny on  Wed Sep 26 17:00 CST 2001 [RELATED]

OK, I only want to do this once.

On reinstalling the oil pump/dist drive gear, the shop manual says install with #1 at TDC, slot at approx 35 degree angle etc. At the end of this section, it states that:

"When the timing gear drive marks are opposite each other, the piston for the No. 4 cylinder as at the top dead centre position, the firing position"

So does that mean that to make sure that my dist. is not 180 degrees off, the marks on timing gears should not be matched when installing the oil pump/dist shaft? Or is TDC with the marks matched up the correct reference for the installation of the drive gear?

thanks





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B20 rebuild - oilpump/dist gear orientation [120-130][1967]
posted by  someone claiming to be Danny  on Wed Sep 26 17:00 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.