Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Do these specs show a working O2 Sensor? 200 88

posted by  someone claiming to be Bruce on  Wed Oct 3 15:42 CST 2001 [RELATED]

88, 245

Bosch Jetronic

3 wire O2 sensor

Recently I tested my O2 sensor. I used the Haynes manual that says to disconnect it. I may have tested the wrong end of the connector too. But I got a steady .500 most of the time. sometimes it would go to .001 or .000 (nothing). So today I use the Bentley manual and it says to leave the sensor connector, connected. I did that. No .500, just a .001,and then suddenly it started flashing various numbers, from .002 thru .007 and everything in between. The suddenly it would go back to .001 or .000 Is this a good or bad O2 sensor? (Not sure if the meter is not what it could be or if it is okay. The numbers seemed to flash by when I pushed the tip of the probes into a negative ground harder. I use the bolts at the top of the strut towers to ground the meter.) Bruce and a family full of Volvos.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Do these specs show a working O2 Sensor? [200][88]
posted by  someone claiming to be Bruce  on Wed Oct 3 15:42 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.