Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Inserting studs and intake manifold torque 200 84

posted by  someone claiming to be Jessie on  Tue Oct 30 14:54 CST 2001 [RELATED]

I have never put a stud in before. How do you screw it into the block without wrecking the threads? Why don't they just use bolts? I am putting the intake manifold back on but my Haynes manual does not list how much torque to put on the nuts. Or is there a torque? It would be nice if there was not, since I don't have a torque wrench anyway. All I know is that they were not very tight when I took them off.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Inserting studs and intake manifold torque [200][84]
posted by  someone claiming to be Jessie  on Tue Oct 30 14:54 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.