Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Need an electrical guru's help now. 86 245 200 1986

posted by  someone claiming to be Luke Healey on  Fri Jan 4 08:48 CST 2002 [RELATED]

Ok,

I have posted a few times recently about my 245's problems.

a recap: The car will barely run with the AMM hooked up.

unhooking the AMM results in an easy start and idle.

So, I patched in a new ECU and the symptoms remained the same.

So then I broke down and got a replacement Air mass meter and thought for sure I would have things licked, but NOPE.

With the new AMM, the symptoms are the same. starts and idles without the AMM hooked up but with it hooked up, dies.


Anyway, the wiring harness I have installed is a replacement I bought in the fall from ebay.

It looked fine though, but I'm wanting to know of some possible things to trouble shoot in the wiring harness. I am pretty sure I hooked it all up properly. But now I'm worried that the problem may lie in the wiring.

Do any of you old pros have any suggestions?

I have 2 air mass meters, two ECUs, and i'm clueless :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need an electrical guru's help now. 86 245 [200][1986]
posted by  someone claiming to be Luke Healey  on Fri Jan 4 08:48 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.