Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

auxillary shaft bearing fit 200 1980

posted by  someone claiming to be William Marotta on  Fri Jan 11 11:00 CST 2002 [RELATED]

I have an engine from a 1980 volvo 242. The engine had needed to be reuilt, and I ordered bearings for the auxillay shaft - part numbers 463360-8 for one bearing, and part number 463361-6 for the other two bearings. There is no way this shaft is doing to fit. I there is at least .005 inch interference fit on auxillary shaft bearing journal number 3 and number 2 bearing. The only way I see to fit this is to replace the bearings again-- i checked and i am being told that i have the correct bearings, -- or to hone this out so that the shaft has proper bearing clearnace. Have any of you here seen this problem? I tried several searches in archives but, either i dont know what i am doing, or there is nothing listed about this sort of problem?

william marotta -- wmarotta@aol.com

stillwater oklahoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New auxillary shaft bearing fit [200][1980]
posted by  someone claiming to be William Marotta  on Fri Jan 11 11:00 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.