Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Ring Gear 200

posted by  Papasmurf on  Sat Jan 19 11:34 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

OK, I took out the starter and it looks ok. Had it checked out and it's engaging properly with plenty of power. So my starting problem must be the ring gear. Visually it looks fine (no missing teeth) so what exactly am I looking for as far as defects to it. Can't get a real good look at it but while uderneath and having someone spin the pulley all the teeth "feel" consistant with one another. So what else can cause the starter to not grab. When I took out the starter, it wasn't loose. The bolts into the bell housing where tight.

Thank you for any help...
Will






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ring Gear [200]
posted by  Papasmurf  on Sat Jan 19 11:34 CST 2002 >
  • New Ring Gear [200]
    posted by  someone claiming to be Jim McDonald  on Sat Jan 19 13:10 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.