Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How much torque for nuts - exhaust manifold and stock rims 700 1990

posted by  invar on  Sat Feb 2 20:58 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Feb 26 21:00 CST 2010
[RELATED]

1990 740 base w/stock 15" steel rims and original exhaust. Just got the gaskets redone on the exhaust manifold, but I'm not sure if the guys torqued it right. Besides, I think I'm supposed to retorque it after some driving to make sure it's sealed up nice and tight. What should the torque be on the nuts that are on the exhaust manifold (goes into the engine block)?

And while I'm at it, what should it be on the lugnuts for the wheels? I'm not sure if it's the manual or not and I'm already in my PJs, and it's 4 in the morning, so I can't check at the moment, so I figured I'd ask all in one message. :-)

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How much torque for nuts - exhaust manifold and stock rims [700][1990]
posted by  invar  on Sat Feb 2 20:58 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.