Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

is it ok to run a new wire to intank pump for a temporary solution??? 200 1982

posted by  someone claiming to be jacob on  Mon Feb 11 01:23 CST 2002 [RELATED]

i have a new intank pump but it does not run. i have replaced the fuel pump relay and still not detection. i think the wiring is shot. i dont want to fork over the 100 bucks for a new sending unit if it is not the problem. can i run a fresh wire from outside the tank through the unused pipe on the sending unit to the pump to temporarily check to see if it works? the unused pipe i am talking about is the third one not used on the lid of the sending unit. it just has a black cap on it.
thanks,
jacob





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New is it ok to run a new wire to intank pump for a temporary solution??? [200][1982]
posted by  someone claiming to be jacob  on Mon Feb 11 01:23 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.