Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Please help - brakes pads out and so are new ones due to piston not going back 200 1991

posted by  gcrowl on  Sat Mar 2 04:18 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Dec 23 20:00 CST 2012
[RELATED]

My 240 wagon is up on the jacks and what I thought was a simple job is not the case. The rear pads are being replaced and one piston is not going back in enough for the new pads to go in. The outside piston pushed back easily but the inside on will not. Any tips would be appreciated. Not sure if I need a rebuilt caliper unit or if bleeding will help or taking the caliper assembly off to get at the piston easiler will help.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Please help - brakes pads out and so are new ones due to piston not going back [200][1991]
posted by  gcrowl  on Sat Mar 2 04:18 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.