Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2014 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Observations when changing a cam 900 1993

posted by  dick on  Thu Apr 4 15:53 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 3 15:24 CST 2014
[RELATED]

Tonight I began the process of upgrading the cam on my 93 940T. Just finished doing my 87 NA last week, but this time there is a bit more going on. First, the engine only has 135K on it, but someone was afraid to change oil and consequently there is a lot of baked on sludge (I removed) in the area around the valves. This was a rather time consuming job, but looks good now. The other thing is the little 'hushers' under the lifter were all shot. Either in pieces or fried from the heat. Cleaned the lifter barrels and installed new hushers.

Hope to polish it off this weekend and see how we fly.

If you start to hear some valve noise in your car and it is high mileage, you might want to seriously think about replacing these little rubber hushers. They are inexpensive and do not change your valve clearance. Your engine will be quieter too.

Love the grease!!

dick






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Observations when changing a cam [900][1993]
posted by  dick  on Thu Apr 4 15:53 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.