Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2017 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Need cam position sensor help. 900

posted by  Rob F on  Fri Apr 5 11:47 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

With the help of this forum I was successful in changing the head gasket in my 960

Everything looked good inside and went back together with only one catch, due to my own foolishness I wiped out the cam pos. sensor.
Is it safe to use the car for a couple of days until I can get the part or do I run the risk of doing damage to anything else? It runs slightly rough but I figure this is due to the bad CMP. (Code 314) or dose it take the computer a wile to reset to normal like the old GMs?
If anyone would like the particulars on the head gasket change e-mail me and I would be glad to share what I learned.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need cam position sensor help. [900]
posted by  Rob F  on Fri Apr 5 11:47 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.