Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 oil pressure sender flaky 200

posted by  thaywood on  Sun May 5 04:10 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 29 08:38 CST 2014
[RELATED]


I installed an oil pressure gauge from a junker in my '87 240. The sender seems to have a dead spot below 3 bar - the gauge reading is stable at 3 bar and above, but once the engine heats up the idle pressure reading gets flaky: it pegs above 5 bar and/or jumps around. I checked the sender using compressed air and an ohmeter, it looks like there is a dead spot (infinite ohms) in the middle range.

Is there a way to fix the sender or is it shot?

Thx,

Terry





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 oil pressure sender flaky [200]
posted by  thaywood  on Sun May 5 04:10 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.