Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

egr system question & unknown fitting on k-jet [picture] 200

uid 7315's pic
posted by  n1tr0 on  Fri May 17 17:32 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

it looks like the previous owner crimped off the egr tube that runs around behind the engine when it rotted out, now that i'm pulling the exhaust manifold to replace the gaskets, can anyone tell me why i wouldn't remove the whole system ? ie. cap it at the throttle body, exhaust manifold, & the vacuum tube/valve ?
can anyone identify the fitting between the intake boot & the fuel lines on the fuel system ? just wondering if there should be a line attached to it & where it might go ?
thanks =)
kristen
--
-- '82 245GL, B23E, K-cam, under restoration, 350k km --







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New egr system question & unknown fitting on k-jet &#091picture&#093 [200]
posted by  n1tr0 subscriber  on Fri May 17 17:32 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.