Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Machining new 'flats' on inner tie rods. 200 1993

posted by  raidman on  Sat Jun 29 04:45 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

Thanks to all who aided me in the previous discussion of inner tie rods for steering rack rebuild. I still am mulling over the fact that the new inner tie rods from FCP Groton do not have "flats" for turning. This is not a problem, I can use a pipe wrench to turn them onto the rack end and a little LockTite.
The problem is with the washers that are supposed to be peened over onto the "flats" after installation. There were no new washers included in the boxes with the new tie rods and the person at FCP Groton was not overly concerned that they were not included.
I have access to a machine shop, so I could get "flats" turned onto the ends of the new inner tie rods, and reuse the old washers (new surface to peen). This seems a lot of trouble for a saftey feature that should be included in the manufactured of even aftermarket auto parts.
Are there other suppliers that sell inner tie rods with the flats and new washers?
Other than this, I've had nothing but GREAT experiences with Nick at FCP Groton.
What say you, O VolvoGurus?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Machining new 'flats' on inner tie rods. [200][1993]
posted by  raidman  on Sat Jun 29 04:45 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.