Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Removing ignition tumbler assembly from 1981 240 200 1981

posted by  JSully on  Mon Aug 26 23:44 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am tiring of using a screw driver to start my 1981 245. The key itself still urns nicely in the cylinder, but the cast part that twists the electrical portion of the ignition switch has broken off. Is it possible to remove the cylnder/tumbler without removing the entire assembly from the steering column? I have discovered a small (1/8") pin inserted into the steering column side of the tumbler. Is this the secret?

I have found a replacement igntion tumbler assembly in my favorite junk yard and would like to remove the tumbler from it without removing the whole assembly from the column as well (it also as a functional key). Thanks.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.