Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

safe removal of moulding clips? 200 1983

posted by  susan on  Wed Aug 28 14:15 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 14 22:24 CST 2014
[RELATED]

Hi,

What is the best way to remove the plastic moulding clips that snap into the body? The trim i'm talking about is the 4-piece trim that runs horizontally from front to back of car, about 6 inches or so below the bottom of the windows. The trim is usually chrome with black rubber on the bottom.

I was able to pull a complete set of moulding from a pick-n-pull with the clips intact, but my driver-side door and one of my front quarter panels still has old clips in there from when the old moulding was there (before i got the car). I want to get the old clips out without damaging the paint but am not sure the best way to go about it.


any tricks or tips on this are appreciated.

thanks!

susan.

--
Emperor for Life - Leaky Volvo Club of America (LVCOA)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New safe removal of moulding clips? [200][1983]
posted by  susan  on Wed Aug 28 14:15 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.