Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 Speedo Question 200 1986

uid 1's pic
posted by  JSBB on  Sun Sep 8 12:55 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 14:42 CST 2014
[RELATED]

The speedometer went out on the wagon a few weeks back. I finally got around to trying to see if I can fix it. What I tried:

  • Continuity between the speedo head wires and the sender connection. OK
  • Ohm reading of sender at rear connection. 3.19 k Ohms. This is outside the range indicated in the Bentley book.
  • drove around with the voltmeter on the sender wires on the instrument cluster. It was roughly 3.5mV at 15 MPH. It did rise with increase in speed.
  • Removed speedo from instrument cluster to inspect the plastic gears. They look fine.

    I was reluctant to take off the sender. Also, I did not check the clearance of the sender.

    Given this information, what advice can anyone give me? I'm thinking I'll just take it to a mechanic on this one. But I fear they'll go the expensive route, when a simple approach would do just fine.

    Thanks.

    -JSBB






    • THREADED THREADED EXPANDED FLAT PRINT ALL
    MESSAGES IN THIS THREAD

    New 240 Speedo Question [200][1986]
    posted by  JSBB subscriber  on Sun Sep 8 12:55 CST 2002 >


    << < > >>



    ©Jarrod Stenberg 1997-2022. All material except where indicated.


    All participants agree to these terms.

    Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.