Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

control arm bushings 200 1989

posted by  twoforty's on  Sun Sep 8 15:52 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 18 14:54 CST 2013
[RELATED]

Front end rebuild time. All apart, except one control arm (murphy is working). The front bushing (smaller of the two) bolt seems to be firmly attached to the inner metal sleeve. The end nut came off with no fuss. The bolt....just wont break free. The entire control arm moves with the twist of the bolt. The opposite side was taken aprt with no hassel (so now Im paying). Im letting the penetrating oil do its' magic over night. Any suggestions, ideas,tips, tricks, what have you, would be greatly appreciated.
Oh, I tried hammering the bolt out; rocking the bolt back and forth, along with gallons of penetrating oil and sweet talk.
Thanks in advance.
Al, 84/ 242GLT & 89 /245






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New control arm bushings [200][1989]
posted by  twoforty's subscriber  on Sun Sep 8 15:52 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.