Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2011 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

still have codes 113 and 115 900 1994

After consulting with the board a few weeks ago I resoldered the ground wires to the injectors under the intake manifold. Took 3 1/2 hours. Still have the same codes and MIL light. The car runs great but with the MIL light still on it is running in a default mode, it is probably tanking my converter. Does any body have any ideas on where to look next? Since it still runs I don't think there is a problem with any of the injectors they check out at around 18 ohms each, the book says to be around 16 ohms. I think there is a missing ground somewhere, this is just a guess though. This event occurred about 3 days after I cleaned the engine compartment with a high pressure sprayer with no soap. I have done this many times in the past without and negative effects.

Thank in advance for any and all suggestions.

DanR 94 964 204k miles
--
DanR






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New still have codes 113 and 115 [900][1994]
posted by  DanR subscriber  on Tue Sep 10 08:06 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.