Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Who has DIY replaced their cluth? (M46) 200 1982

posted by  Bob Wennerstrom on  Sat Sep 14 06:47 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 15 12:01 CST 2011
[RELATED]

Lotso questions here, trying to get prepared for this job. I've done clutches before but usually really hate myself about the time the transmission needs to go back in. Anyone got helpful advice here? These are the issues I can think of. I should probably put in a rear main engine seal while I'm there right? any other seals I should order with the clutch? What about a piolt bushing/bearing? Also, what do I use for/where do I get a clutch alignment tool? Thoughts on resufacing the flywheel? and lastly, can I reuse the flywheel bolts?

As always, Thanks for any help.

Bob
82 intercooled turbowagon
A bunch of Amazons







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Who has DIY replaced their cluth? (M46) [200][1982]
posted by  Bob Wennerstrom subscriber  on Sat Sep 14 06:47 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.