Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2018 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Just about to replace O-rings in J-type OD-> Should I do anything else?? 120-130

posted by  malloy1 on  Sat Oct 12 15:36 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 17:44 CST 2014
[RELATED]

Just about to pull the OD from my 122. It's slow to engage-> runs fine when engaged-> disengages fine.

I was just going to replace the piston O-rings + OD-to-adapter gasket. IPD sells a mini rebuild kit(CU4160) for a M46/J-type, but only sells a gasket/seal kit(2B5416) for a M41/J-type. The mini rebuild kit looks like it replaces most the important parts(all o-rings/springs/seals), and the gasket/seal kit looks like it only replaces the piston O-rings? I thought the J-type OD's are about the same? Is the piston O-rings in the M41/J-type OD the only internal parts I need to worry about, or should look into replacing something else since the OD is out??

Any suggestions????

Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Just about to replace O-rings in J-type OD-&gt Should I do anything else?? [120-130]
posted by  malloy1  on Sat Oct 12 15:36 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.