Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

fog light mounting 200

posted by  janglim on  Sat Oct 19 14:52 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 9 11:55 CST 2014
[RELATED]

So I picked up a set of bosch pilot fogs at the junk yard and am wondering what to do with them or if I really want them at all.
I'm looking for tips on how people have mounted them satsifactorily below the bumper.
I have the early 80's air dam with no vent/scoop for air to the radiator. The obvious mounting points - the outer pair of bolts up through the bumper - put the fogs too wide and too far forward for my tastes - they project 1/2-1" beyond the bumper. Bad for frequent parallel parking too. The corresponding inner pair of bolts have the same problem of too far forward, and also interference with the lisence plate mount.
Is there a better way to mount them cleanly? I've seeb 700's with holes in the air dam for fogs. Don't suppose one of those dams would fit?
I've been looking at the later 80's version of the 240 dam with the three hole air scoop, but they don't seem to accommodate fogs any better.
Any ideas?

Joe






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New fog light mounting [200]
posted by  janglim  on Sat Oct 19 14:52 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.