Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing bearing for driveshaft procedure and time estimate 200 1986

posted by  someone claiming to be bearnoel on  Sun Oct 20 15:52 CST 2002 [RELATED]

What would be the normal time a properly equipped machanic should take to replace the center bearing and the donut support on a 1986 240 wagon? Is two hours enough? Also can one remove the front half of the shaft only and leave the rear half-shaft attached to the differential.

I am getting the spare parts. Can anyone comment on the durability of Scan Tech bearings compared to Volvo's? What I have now is Volvo's but it it noisy and just about gone after only 25000 miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing bearing for driveshaft procedure and time estimate [200][1986]
posted by  someone claiming to be bearnoel  on Sun Oct 20 15:52 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.