Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

driveshaft alignment 200

posted by  someone claiming to be lanky on  Wed Oct 30 03:55 CST 2002 [RELATED]

Took the rear u-joint off the pinion flange on an 87 245 the other day after marking the position with a "magic" marker....only to find that when it was time to reconnect it, the magic marker had rubbed off. In reading the board, I find two schools of thought on alignment..one guy says if the front ujoint is vertical, then the last ujoint should be horizontal on the pinion flange. Another says they should be in the same attitude? Who is right? And does the last ujoint only go on the flange in two positions (180 degrees from each other) since the holes don't line up otherwise? I did not pull the slip yoke out of the center bearing. Please help..thanks. lanky






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New driveshaft alignment [200]
posted by  someone claiming to be lanky  on Wed Oct 30 03:55 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.