Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacing sensors below intake manifold. 200 1981

posted by  DougC on  Sun Dec 15 10:06 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 10 08:30 CST 2014
[RELATED]

1981 242 Non-turbo: While I have the intake manifold off I'm figuring on replacing the coolant temp sensor, engine temp sensor and thermo time switch. They total $60 at Grotons, but I figure it's probably a wise investement. Do these three screw in dry or should something be put on the threads before installing them? Also, what about the second thing that is mounted below number 2 intake port? I've been told not to bother replacing this. Actually, sometimes I wonder if I should replace any of them. Thanks in advance. DougC






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing sensors below intake manifold. [200][1981]
posted by  DougC  on Sun Dec 15 10:06 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.